Creates spectacular 3-metre fountain jets with 5000 LPH flow from twin 80W panels, controlled by remote up to 100m away – the most powerful floating fountain in the range.
Set the floating assembly on the water surface and place the two solar panels where they receive strong direct sunlight. This kit is intended for larger ponds and calm water areas, and keeps the pump positioned at the surface while the spray head operates during daytime conditions.
✓ 160W solar (2 × 80W)✓ Flow up to 5050 LPH max✓ Max head up to 3m✓ Remote control up to 100m✓ Dry-run + locked rotor protection
Designed for Larger Ponds
The floating assembly keeps the pump stable at the surface while the fountain spray head
provides a visible pond centrepiece. For best results, position the panels in open, unshaded
areas with strong direct sunlight throughout the day.
Fountain Performance
Maximum head up to 3m
Maximum flow up to 5050 LPH
Two nozzle spray styles included
Bell or volcano fountain display
Output varies with sunlight
Remote Operation
Remote control range up to 100m
Simple on/off control from shore
Ideal for larger pond layouts
No mains wiring required
Operates automatically in sun
Built-In Protection Features
Dry-run protection shut-off
Locked rotor safety function
Brushless DC motor efficiency
Low-voltage electrical safety
Designed for daytime use
Care & Seasonal Notes
Keep the pump intake clear of debris and clean the panel surfaces when needed. Remove the
system before freezing weather and store dry during winter conditions.
This solar floating fountain kit is designed for simple assembly in larger ponds and calm
water areas. The system floats at the surface while the solar panels provide direct daytime power.
Step 1: Assemble the Float
Lay both panels face down
Fit the centre mounting bracket
Attach both floating barrels
Check balance before tightening
Secure all bolts carefully
Step 2: Fit the Pump
Screw pump into centre mount
Tighten securely by hand
Keep outlet facing upward
Fit nozzle after switching off
Select bell or volcano spray
Step 3: Position on the Pond
Place fountain gently on water
Keep panels fully unshaded
Anchor with rope if needed
Avoid drifting into edges
Switch on using the remote
For best performance, keep the panel surfaces clean and remove the unit before hard frost
or freezing conditions.
The twin 80W solar panels generate electricity in direct sunlight and feed a low-voltage
controller that powers the brushless DC pump. Water is circulated upward through the spray
nozzle and returned to the pond surface.
Solar Daytime Operation
Runs in direct sunlight only
No battery backup included
Flow varies with light levels
Stops in very low sun
Best in open, bright ponds
Brushless DC Pump System
Efficient brushless motor
Low-voltage DC operation
Built-in dry-run protection
Locked rotor safety function
Designed for long service life
Spray Display Notes
Two nozzle styles included
Bell spray up to ~1.2m high
Volcano spray up to ~1.8m high
Spread up to ~2m wide
Performance depends on sunlight
This system is ideal for daytime fountain displays in larger ponds where cable-free solar
operation and strong output are preferred.
