Lights up cupboards, wardrobes and kitchen counters the moment you move, with three colour settings, five brightness levels and a magnetic, tool-free fit.
Two 25cm light bars in white
Switches on by itself when you walk past in the dark
Warm, natural or cool white at the press of a button
Two slim, rechargeable light bars that switch on as you open a cupboard, reach into a wardrobe or walk down a dark hallway, then switch themselves off again. Fix them with the built-in magnets or the stick-on iron plates, and take them down to recharge whenever the display tells you to.
No tools, wiring or drilling. Each bar takes a couple of minutes to fit.
1. Charge First
Fully charge each bar before first use with the USB-C cable supplied. It takes about 1.5 hours; the display shows 100% when it's full.
2. Pick the Spot
Choose where the light should fall: the top of a wardrobe, the underside of a wall unit or the inside of a cupboard. Keep the sensor end facing where people will move.
3. Steel Surface?
If the surface is steel, simply place the bar on it. The built-in magnets hold it in place.
4. Any Other Surface
Clean and dry the surface, peel the backing off an iron plate and press it on firmly. Then place the bar on the plate.
5. Set It Up
Choose auto or always-on mode, then pick your colour and brightness with the buttons. Walk past to check the sensor picks you up.
6. Recharging
When the display runs low, lift the bar off its plate, charge it by USB-C and put it back. The plate stays where it is.
