Sunspray se 500 Spare Pump with dry run protection (Pump Only)
Place the solar module in direct sunlight facing the sun to run the pump on solar energy, noting that orientation and sunlight intensity affect performance. The pump is powered via a battery unit that is charged by the solar module.
2) The pump is supplied by the battery unit which is charged by the solar module.
3) The pump introduces the latest DC brush-less motor technology, it has high efficiency and long service life, and it has built-in function of dry-run protection. Two sensor points are provided on the side of the housing for dry-run protection. The pump works if these points are under water. If a point projects out of the water, the pump does not work.
4) The pump flow rate can be adjusted by the means of the flow valve.
The dry-run system uses two sensor points, and both need to be underwater for the pump to operate. If the water drops below them, the protection stops the pump. Keep the reservoir topped up so the sensors remain covered; this is a water-level safeguard rather than a diagnosis of every possible stopping fault.
Can I adjust the water flow after fitting the replacement pump?
Yes, use the pump’s flow-control valve to adjust the water flow for the display. Keep the pump and its water-level sensors underwater while testing the setting. The quoted 330 litres per hour is a maximum flow figure, so it should not be read as a guaranteed flow through your fountain at every lift.
Does the replacement include a new solar panel or battery box?
This is the pump-only replacement for an existing SE 500 setup. It connects into the existing system, where the solar panel charges the battery box and the box powers the pump. The pump lead is five metres long. A new panel or battery box is not part of this pump-only replacement.
Сonsultation
If you have questions, please ask, do not hesitate,we are always happy to help you