ConnectGo Small Transformer, Green Cable

Overview & Setup

Select a compatible power source for your chosen ConnectGo lights, then plan where the transformer and lead will run to suit your layout. The dark green cable is intended to blend in when routed along foliage or fixings, while keeping the plug indoors or in a suitable weatherproof enclosure.

When you have chosen the lights you require from our low voltage ConnectGo range, it is essential that a power source is purchased to power them.

The ConnectGo small transformer is manufactured specifically for use with this range, & will power up to a maximum of 600 LEDs.

Our 31V digital transformer boasts 8 different functions including: Combination, In Waves, Sequential, Slow-Glow, Flash, Slow Fade, Twinkling, and Steady On.

Each time you switch the lights on, the built-in memory chip will automatically select the last function used.

Remote Control And Dimmer

The remote control selects any of the 8 functions, sets the timer and adjusts the brightness through 4 dimmer levels. It works up to about 8m from the controller. The same settings are also on two buttons on the in-line controller.

Set The Timer Function And Go!

The handy timer function allows you to leave the lights switched on; they will remain illuminated for 6 or 8 hours (your choice),
before turning off for 18 or 16 hours and then turning back on at the same time as the previous day.

Easy to use: choose a function with the remote or the button on the controller. To activate the timer, hold the button down for 3 seconds.

The button will illuminate green to signal the timer is engaged; you can still cycle through the different functions whilst in timer mode.

Please note: the mains plug must be indoors, or in a suitable weatherproof enclosure. The 5m green lead cable can be used outdoors.