Slate Water Feature in Natural Plum

General Installation of the Stone Water feature

Can be Installed Above or Below Ground (If above Ground the Reservoir will need support via bricks inside)
For below Ground you will need to dig an appropriately sized hole, use reservoir for marking (upside down) place the reservoir in this hole flush and level - ensure the reservoir is level and back fill space with earth or sand.

- Place pump inside reservoir, fix tubing (included) to pump, place grid on reservoir, thread tubing through grid & pump lead through side of grid (through one of the grid holes)
- place stone centrally on grid & thread tubing through stone (hole drilled in stone) cut excess tubing off
- Connect the lead from the pump to the battery, then connect the battery to the panel, place panel in sunny location
- Fill reservoir with water
- Cover the remaining Grid with Your choice of stones
- To Install Above Ground You will need to support the Reservoir Tub, place bricks inside the reservoir tub that reach up to the grid, so that inside the tub there are at lest two columns of bricks, so that the weight of the rock is supported from grid to the base of the reservoir. Enjoy !!

General Installation of the Solar Water Pump

- Unpack all components carefully.
Connect the "INPUT" cable of the battery back-up to the solar module, and tighten the screw for protection. Unfold the solar panel and fasten it with the panel fixture. Install the solar module at a sunny place, adjust the angle let the solar module facing SOUTH toward mid day sun.
- Insert the pump plug to the OUTPUT socket of the battery back-up, and also tighten the screw.
- Connect one nozzle on to the pump then connect the tube and thread through the stone.
- Make sure to place the pump fully underwater when the pump operates.
- Turn the switch to the position "ON". The green LED illuminates. The solar pump is starting to operate. The LED may illuminate RED while it operates at first time, because the battery will lose energy slowly in stock. It just needs to be charged for 2 to 3 hours in the sunlight, then it will change to GREEN and the pump starts to work.
- The pump will automatically stop running while the battery is discharged to its lower limit voltage, and the red LED illuminates at the meantime.
- When the battery is recharged to its starting voltage, the LED will flash RED-GREEN twice every 10 seconds, and it will last 30 minutes. Then the pump will automatically operate and the LED illuminates GREEN again.
- Adjust the regulator switch to get different pump performance. The pump can operate at the voltage range of 12V-24V.
- urn the timer switch to the position "ON", the pump works 15 minutes every hour. It can save the battery energy in this operating mode, especially for winter or cloudy day use.
- The HIGHER the pump is in the water reservoir the less work it has to do so running times are longer and more consistent the higher the pump, you can raise the pump with an upturned flower pot or brick.

If you want to have long operating time in the evening, then turn the switch to "OFF" position during the day and turn it "ON" whenever you need.